As an Amazon Associate I earn from qualifying purchases.
1. TCMMRC #ad
TCMMRC FC F4 Flight Controller OSD 2-5S DSHOT600 for RC Drone FPV Racing 30.5x30.5mm #adTCMMRC #ad
- F4 flight controller；mcu: stm32f405； gyro: icm20602 6-axis；bec: 10v 1A；Support Receiver:PPM, Ibus, Sbus, Dsmx. Customer first-if the esc flight control is due to quality problems, please contact us in time and we will solve it for you.
4 in 1 40a blheli_s esc；continuous current: 40a； peak current: 50a 10s；bec: 5v 2a bec；input voltage: 2-5s；main control chip: 48mhz EFM8BB2；Firmware upgrade: Supports Dshot600/BLHeli_S/Oneshot125；MOS: 5*6.
F4-40a stack is convenient for beginners. Mounting hole:m3*305*305mm；suitable for 4-7 inch Drone Frame. Easy to solder, the f4 flight controller has multiple ports, No soldering, just plug in the port line.
2. Usmile #ad
Matek System F411-WSE F4 Flight Controller with OSD Inav Firmware Dual Camera Inputs for RC Plane Fixed Wing FPV Aircraft Glider Sailplane Airplane Similar with F411-WING F722-WING F405-WING #adUsmile #ad
- Osd: at7456e, 2x uarts, current, 4x servos outputs. Tr/sa vtx control: Yes. 3x leds for fc status blue, red and 3. 3v indicatorred. 4x adc vbat, 2x motors, rssi, 2x Softserial, AirSpeed.
Voltage devider for Analog Airspeed sensor: Yes. This is a great fixed wing flight controller. Switchable dual camera inputs allow you to mount two cameras facing different directions, enjoying beautiful views otherwise could never be seen.
It features dual camera inputs like f722-wing, other features including 100MHz STM32F411, MP6000, bmp280, AT7456E OSD. Please check listing picture to see the differences between F411-WSE F411-WING F722-WING F405-WING. Rssi: Yes.
3. BETAFPV #ad
BETAFPV F4 FC 1S Brushed Flight Controller with SPI Frsky Receiver OSD Smart Audio for FPV Tiny Whoop Micro Racing Drone #adBETAFPV #ad
- Built-in betaflight osd stm32 controls OSD chip over SPI in DMA mode. In betaflight configuration, taranis plus, x9e, it should be setted as FRSKY_D receiver aka Frsky D8 mode or FRSKY_X receiver aka Frsky D16 mode in SPI RX mode.
The flight controller board comes pre-flashed with betaflight firmware, and pre-soldered 55mm power cable pigtail with JST-PH 2. 0 connector, AKA PowerWhoop connector. The default configuration from factory is frsky d16 mode frsky_x.
F411 processor can reach to 100mhz, much faster than the f3 flight controller with 72mhz. Integrated with frsky receiver only. Upgraded to 30a lower resistance MOSFET, Firmware version: betaflight_matekf411rx_3. 4. 0 Built in frsky receiver is compatible with taranis, Horus X12S, XJT Modules. Support Smart Audio. Designed to work with current Tiny Whoop or Blade Inductrix setups.
4. HGLRC #ad
6S FD411 Flight Controller Stack 35A BLS 4in1 ESC Electronic Speed Controller 20X20 M2 M3 for RC Racing Drone Quadcopters & Multirotors Red, HGLRC Red F4 Zeus35 AIO 3S #adHGLRC #ad
- Why choose us we are the original hglrc manufactory, feel free contact us, if there are any question or need help, we will always here help you out within 24 hours . High-end quality built-in current sensor and support SBUS/PPM/DSMX receiver, high quality durable suit for most of RC drones quadcopters.
Easy operation dimension: 40x32mm board, Very easy to welding, 20mm mounting pattern M2/M3, friendly to beginner or professional racing drones.
Efficient & lightweight f4 zeus35 flight controller built-in 35a blheli_s 4 in 1 ESC Electronic Speed Controller, tiny size, ONLY 10g, great items for 2in -5in mini indoor outdoor racing drone quadcopter micro class racers.35a 4 in 1 escoriginal parts support dshot 600 / 300 / MultiShot / oneshot 42 / oneshot125 / 150 / Damped Light mode. Click the orange Button to Buy Now :. Choose us risk free today.
5. SPEEDY BEE #ad
SPEEDY BEE F7 Flight Controller Stack 30x30,BF/EMU/INAV Supported,Wi-Fi&Bluetooth, Blackbox,Configuration and Firmware Flash via APP, 45A BLHeli 32 4-in-1 ESC for FPV RC Racing Drone DJI #adSPEEDY BEE #ad
- No more need a laptop: configure your fpv drone, or fine-tune your PIDs, access your blackbox data, and configure any other parameters in just a few minutes. Bf/emu/inav full support: whether you're at home or the field, your speedyBee F7 V2 is ready for you all the time.
Support 45a continuous output and 55A burst output10s, ready for your strongest 6S motors. First flagship 4-in-1 esc: built with the finest components, speedybee's latest flagship ESC features a pure and high performance.
Even can configure motor direction wirelessly. Support blheli 32 ESCs. Just need to connect speedyBee App, it supports Betaflight/EMU/INAV full configuration. Easily connect to dji air unit: v2 f7 fpv fc included a connector specifically for DJI air unit, so installation should be a breeze.
World's first fc stack with wireless firmware flasher and blackbox analyzer: To simplify FPV, SPEEDY BEE creates the world's first FC stack that can flash the firmware and analyze the blackbox wirelessly anywhere just need a phone. Usb type-c and 22mm cutouts for FPV camera on FC and ESC boards compact more fpv frames.
|Brand||SPEEDY BEE #ad|
|Manufacturer||SPEEDY BEE #ad|
|Part Number||SPEEDY BEE V2|
6. SunriseModel #ad
OSD, 30x4 BLHeli_S DSHOT ESC, PDB w/BEC, SunriseModel Cicada AIO Flight Controller F4, Current Sensor #adSunriseModel #ad
- 30a continuous 35A burst. 3-4s lipo. Blheli_s. Current sensor. Compatible with dshot 600 without modification.
7. Aoile #ad
Aoile Mini F4 Flight Controller Stack 20x20 35A 2-6S 4 in 1 ESC for Whoop Tinyhawk cinewhoop FPV Racing Drone Quadcopter Default #adAoile #ad
- Stm32 f405 mcu fc w/osd, integrated MPU6000 accelerometer and gyro. The pad is semi-extended, but is stronger. Built-in programmable rgb led interface to adjust the color, function and status of LED, built-in osd chip can monitor flight data status at any time, smartaudio function is available.
The newly launched flight control f4 is optimized, the main welding port is upgraded to a terminal plug, a plug-in connection, and the needle seat design is convenient for pilot assembly and disassembly.
Compatible with sbus, spektrum1024/2048, xbus, sumed, etc. Sumh, ppm receiver, the exit door of the electric bell allows to connect an external electric bell to the FC to warn or inform the flight status. Compared with the standard size, which saves more space, it is greatly reduced, and the performance is excellent.
8. Karcy #ad
Karcy Rubber Damper Balls M3 Rc Anti Vibration Ball for F4 F7 Flight Controller Purple Pack of 30 #adKarcy #ad
- The latest f4 f7 flight controller for FPV quadcopter aircraft frame with anti-vibration function. This rubber damper ball can effectively reduce the sensitivity of the flight control and is a must-have for every pilot who pursues extreme flight.
Overall size: 6x6. 6mm / 024x026"dxh; inner diameter: 3mm / 1/8". Package including: 30pcs x Shock Absorption Balls; Material: Rubber; Color: Purple. Easy to install, light weight, suitable for aerial photography, no load on the aircraft, improving aerial image quality.